Name: 36202 Moto Faceplate Grey
SKU: 36202
Availability: InStock

36202 Moto Faceplate Grey

Grey faceplate for 1993-1996 Moto Massage used with Hot Spring Grandee, Jetsetter and Sovereign models.

The Moto-Massage is a jet that automatically travels up and down to massage a person’s back. The mixing of air and water in a jet along with a pliable spine causes the sweeping motion of the Moto-Massage. The intensity and speed of the Moto-Massage can be adjusted with the air control valve.

The Moto-Massage consists of a jet nozzle, water tube, threaded fitting, vertebrae and an air tube with o-ring. The Moto-Massage is held in-place by a special recess behind the spa shell. A guide body is used to assist in proper movement of the Moto-Massage.

The following are the major causes of Moto-Massage failure:

Guidebody misadjusted.
Low Water flow due to jet pump malfunction or dirty, clogged filters.
No or improper air mixture due to air valve failure, airline disconnected, frozen airlines, or non-operative check valves.
Moto-Massage nozzle misaligned.

Specifications
Open or remove the spa cover. Using a large flat blade screwdriver, carefully remove the two screw covers located at the top and bottom of the Moto faceplate slot. Unscrew the faceplate retainer screws and remove the faceplate. Remove the four retainer screws holding the Moto guidebody in place. Make sure to denote the location of the screws for reinstallation. Remove the guide body. Reaching into the Moto niche, locate the small air tube and slide the o-ring and tube off of the small barbed fitting. With your hand still in the Moto niche, grasp the Moto Massage vertebrae located closest to the rear of the niche. Important: Do not grasp any other vertebrae as damage to the Moto assembly may occur. Slowly unscrew the Moto Massage from the niche by turning the assembly counter clockwise. To reinstall the Moto Massage, reverse steps 1 to 7. Important Instructions Regarding Moto Massage Alignment: In order the for the Moto Massage to operate properly it is imperative that the Moto Massage nozzle be properly positioned after the assembly is tightened in the Moto niche. To properly align, ensure that the two holes located on the nozzle face are position horizontally and that the Moto assembly travels vertically within the niche.